How to Clean the Dust From a Phone Speaker

They get lint and dust and all kinds of other dirt over time. You might not even notice them. Leaving them dirty for a while will start to make your sound a little less clear. Some great do-it-yourself ways to clean your phone's speakers before you go to the repair shop:

Here's How to Fix Your Phone's Sound with This Cool Trick!

Go to your web browser and fix my speaker dust type in the address.

• "Tap to start the blowers" is at the top of the screen.

• Click on the icon.

• Sound will be made

• Play it at a high rate, because the more often you play it, the faster the dirt will be removed.

• Three to four times, play this sound.

• Congratulations! You have made your phone sound better.

• The back of your phone should be turned up during this process.

Because this isn't at the service center, you don't pay for it. And you don't have to wait for a whole night or use a toothbrush to do it. You can save this page to your browser. It can help you avoid a lot of accidents that you didn't expect. How?

Compressed Air Can Be Used to Blow Out the Dirt.

Connect the straw to the nozzle of the can to make it easier to get the can in the right place. Screw the thin straw into the nozzle of your compressed air can and you're ready to go. If you want to see how it works, point the nozzle down and press it down.

• If you can feel air coming out of the sides of the nozzle as you spray, you should tighten the straw to stop it.

• If you don't need the straw to aim your compressed air can, don't use it.

In three to four short blasts, blow compressed air into the speaker slot. This will make the speaker work better. It's best to keep the straw's nozzle or tip at least 12 inch (1.3 cm) away from the speaker opening at all times. You can do this to get rid of the extra dirt that came from your cotton swab.

1. Make sure that you don't blow too close to the speaker, because you could damage the phone's internal electrical parts if you do that.

2. In this case, hold the straw in your non-dominant hand as you blow air to keep it steady.

Getting the Speakers From the Inside Cleaned

In order to remove the back lid from your phone, use a suction cup and a spudger. Use a hairdryer on low heat to heat the outside of your phone for about 15 seconds. After that, put a suction cup on the back. As you have the screen facing down, gently pull the suction handle toward you until the screen comes out.

It's also a good idea to put the flat end of a spudger in between the perimeter openings and push it toward you. Lever the back piece while pulling on the suction cup until it comes off. From your local hardware store, you can buy the tool called "spudger," which has an end with a wide flat-head screwscrew. It can be used as a wedge. s

Heat up the outside of the phone if you're having trouble. This will help loosen the glue that holds the two parts together.

Hands can be used to get the back off of some older and cheaper phones, but not all of them. If your phone has a glass back, this isn't possible.